The Trenz Electronic TEI0024-01 MAXCO2 is a compact evaluation kit for precise CO2 measurement of the ambient air in rooms and displays pre-defined CO2 levels directly via 8 LEDs. MAXCO2 is a combination of the well-known MAX1000 Intel FPGA board, where many tutorials are available, and the high-precision CO2 measurement sensor SCD30 from Sensirion. The board is supplied via a standard micro-USB connector (e.g. mobile phone charger) and shows the current CO2 concentration levels via the LEDs already after a few seconds.
Extended-grade module based on Xilinx Zynq UltraScale+ RFSoC. The module is equipped with 4 x 1 GByte DDR4 SDRAM memory, 2 x 64 MByte SPI Flash memory, USB2.0, Ethernet transceiver and 2 x Samtec Razor Beam Board to Board (B2B) connectors. The system controller CPLD is provided by Lattice MachXO2.
Commercial-grade SoM (System on Module) based on Xilinx Zynq-7000 SoC XC7Z020, with 1 GByte of DDR3L-1600 SDRAM, 32 MByte of SPI Flash memory, 10 x 12-Bit Low Power SAR ADCs, 512 Kb serial EEPROM, Gigabit Ethernet PHY transceiver, an USB PHY transceiver, a single chip USB2.0 to UART/JTAG interface (Xilinx license included), and powerful switching-mode power supplies for all on-board voltages. A large number of configurable I/Os are provided via rugged high-speed board-to-board connectors.