The evaluation board for the XC7Z015 All Programmable SoC (AP SoC) provides a hardware environment for developing and evaluating designs targeting the Zynq-7000 XC7Z015 -1FFG485C All Programmable SoC.
It provides features common to many embedded processing systems, including DDR3 component memory, one-lane PCI Express interface, GigaBit Ethernet PHY, general purpose I/O, and one USB-UART interface. Other features can be supported using VITA-57 FPGA mezzanine card (FMC) attached to the low pin count (LPC) FMC connectors.
Details and ordering in our online shop:
30208 - Zynq PCIe FMC Carrier Evaluation Board for the Zynq-7000 XC7Z015 SoC
Key Features
- Zynq-7000 XC7Z015-1FFG485C AP SoC
- 1 GB DDR3 memory (two [512 Mb x 16] devices) on the processing system (PS) side
- 256 Mb Quad-SPI flash memory
- USB 2.0 ULPI (UTMI+ low pin interface) transceiver with micro-B USB connector
- Secure Digital (SD) connector
- Clock sources:
- Fixed 125 MHz LVDS oscillator (differential)
- Fixed 33.33 MHz LVCMOS oscillator connected to PS (single-ended)
- Fixed 100.00 MHz LVCMOS oscillator connected to PL (single-ended)
- GTP transceivers:
- FMC LPC connector (one GTX transceiver)
- PCI Express (1x lanes)
- Small form-factor pluggable (SFP) connector
- SATA Connector
- PCI Express endpoint connectivity, Gen1 1-lane (x1)
- SFP Connector
- Ethernet PHY RGMII interface with RJ-45 connector
- USB-to-UART bridge with mini-B USB connector
- VGA codec with VGA connector
- I2C bus
- M24C08 EEPROM (1 kB)
- FMC LPC connector
- Quad SPI Flash memory
- Platform cable header JTAG configuration port
- 20-pin TRENZ JTAG header
- Dual 12-bit 1 MSPS XADC analog-to-digital front end
- Status LEDs:
- Ethernet status
- Power
- 12V Input Power On
- FPGA INIT
- FPGA DONE
- User I/O:
- Four (PL) user LEDs
- One (PL) user pushbutton
- One (PL) user DIP switch (4-pole)
- Two Dual row Pmod GPIO headers
- AP SoC PS Reset Pushbuttons:
- SRST_B PS reset button
- POR_B PS reset button
- VITA 57.1 FMC LPC connector
- Power on/off slide switch
Additional information by Dübon Engineering
Other assembly options for cost or performance optimization plus high volume prices available on request.
All modules produced by Trenz Electronic are developed and manufactured in Germany.