Extended-grade module based on Xilinx Zynq UltraScale+ RFSoC. The module is equipped with 4 x 1 GByte DDR4 SDRAM memory, 2 x 64 MByte SPI Flash memory, USB2.0, Ethernet transceiver and 2 x Samtec Razor Beam Board to Board (B2B) connectors. The system controller CPLD is provided by Lattice MachXO2.
Commercial-grade SoM (System on Module) based on Xilinx Zynq-7000 SoC XC7Z020, with 1 GByte of DDR3L-1600 SDRAM, 32 MByte of SPI Flash memory, 10 x 12-Bit Low Power SAR ADCs, 512 Kb serial EEPROM, Gigabit Ethernet PHY transceiver, an USB PHY transceiver, a single chip USB2.0 to UART/JTAG interface (Xilinx license included), and powerful switching-mode power supplies for all on-board voltages. A large number of configurable I/Os are provided via rugged high-speed board-to-board connectors.
The Trenz Electronic TEC0810 is a CompactPCI Serial Card (3U form factor) that can be used as a base for Trenz Electronic modules with a form factor of 5.2 x 7.6 cm. For configuration and service, JTAG and UART are available via USB bridge and 1 Gigabit Ethernet on the front panel. 48 differential signals are available on the backplane.
The evaluation board for the XC7Z015 All Programmable SoC (AP SoC) provides a hardware environment for developing and evaluating designs targeting the Zynq-7000 XC7Z015 -1FFG485C All Programmable SoC.
Low cost small-sized FPGA module integrating a Microsemi SmartFusion2 FPGA SoC and 32 MByte QSPI Flash memory